Swim Spas represent distinct challenges when it concerns covering them.
We can all agree that the swim spa has to be covered when not in use for all the same reasons a hot tub requires a cover. The difficulty is that because of the length of the swim spa and the height of the sides, eliminating and replacing the cover can be a lot harder.
Getting a brand-new swim spa is an interesting occasion in life. You’re looking forward to the workout you’ll receive from using it. Perhaps you’re a little relieved to have actually finally made a selection from the different designs you looked at. At any rate, you probably weren’t believing much about the cover you would use.
Generally, the cover that comes home with your new purchase will be a 4 area stiff foam filled cover that will split in the center and go off both ends.
No big deal.
Up until it begins to get heavy.
Which it always does.
Every rigid foam filled Swim Spa Cover ever made ends up the same way and it is not the fault of the user. It’s a style flaw. Built in obsolescence since as quickly as it is positioned in use over the warm water in your swim spa it is unavoidable.
It’s not from rain, so having a taper won’t make any distinction. In fact you could have it under a roof and the cover will still get heavy.
The factor is the steam from the water. The particles of steam are extremely small as they rise from the water surface. They make their method into the little fractures and crevices in the foam. Then as the steam cools it forms back into a liquid and ends up being trapped in the cover.
It takes place slowly and on a Swim Spa Cover which is made of individual areas, at differing speeds. So eventually you’ll notice one or two of the sections are really getting heavy. The bar lifters on the ends of the swim spa aren’t much assistance because you still need to lift that heavy cover back up onto the spa which is a lot higher than a routine spa.
This is why SpaCap.com created a different style for their Swim Spa Covers
Instead of using a number of foam panels to construct Swim Spa Covers that will ultimately wind up in some land fill, they developed one that uses air chambers that don’t suck up wetness.
In fact SpaCap.com Swim Spa Covers are lightweight, insulate much better, won’t blow away in a wind storm or be harmed by snow or hail.
Covered with Sunbrella Marine material, these covers won’t fade, or fall apart at the joints either. So if you own a swim spa, and you mean to keep using it daily, SpaCap.com has the Swim Spa Cover for it.
If you’re not prepared to order today, bookmark this website so you can discover it once again when you’re all set!